A&D TM-2441 Instruction Manual page 44

To set the program for S-BPM.
Step 1. Set the AUTO switch to "OFF".
Step 2. While pressing and holding the
START/STOP switch until
Step 3. The operations are as follows:
Refer to "8.4. S-BPM Programs".
/
START/STOP switch ...... Decision, next item, end of settings.
To measure the blood pressure during S-BPM immediately.
( Manual blood pressure measurement of S-BPM )
Step 1. If the LCD is hidden, press the
START/STOP or EVENT switch to return to the S-BPM
waiting mode display.
Step 2. Press the
The blood pressure measurements for "1 scope" are performed
immediately.
"1 scope" consists of a set of blood pressure measurements and
interval times which are repeated for the number times in the
measurement count. The last interval time is omitted.
The S-BPM waiting mode is a state when blood pressure
is not measured during the interval time and between the last
"1 scope" and next "1 scope".
switch ..................... Change the current parameter.
/ switch during the S-BPM waiting mode.
/ switch, press and hold the
is displayed on the LCD.
24