Attaching The Product To The Patient; Information For Patients - A&D TM-2441 Instruction Manual

8.6. Attaching the Product to the Patient

8.6.1. Information for Patients

Explain the following to the patient so that they can use the
recorder safely.
Precautions during the blood pressure measurement
Relax the arm and stay quiet when inflation begins.
Stay in the same position throughout measurement.
Avoid vibration and noise during measurement.
Blood pressure is measured for approximately 1 minute
after pressurization. Stay still until measurement finishes.
The measurement process between inflating the cuff to
releasing the air requires up to 170 seconds.
The recorder may re-inflate to measure the blood pressure again
after the end of pressurization. This may be caused by body
motion, etc.
The recorder may startblood pressure measurement after
approximately 120 seconds when measurement data is invalid
and the next measurement is 8 minutes later. This may be
caused by body motion, etc.
The recorder may obstruct vehicle and machine operation.
Avoid vehicle and machine operation while wearing the recorder.
How to stop or suspend the measurement
Press the START/STOP switch to stop blood pressure
measurement. An error code is stored in the memory.
Blood pressure is measured again after 120 seconds.
64