Blood Pressure Measurement Operations; A-Bpm Operations - A&D TM-2441 Instruction Manual

8.7. Blood Pressure Measurement Operations

8.7.1. A-BPM Operations

When A-BPM is started, the blood pressure is measured in
accordance with the preset parameters.
Set the built-in clock and initial pressurization value before
measurement, as A-BPM uses them. Refer to "8.2.2. The Clock
and the Monitor Function of Measurement" and "8.3. A-BPM
Preset Programs".
When the recorder is removed, set the AUTO switch to "OFF".
If the recorder is removed during A-BPM, the inflation of the
cuff starts at the next start time and the cuff may burst.
When A-BPM is resumed, set the AUTO switch to "ON".
The mark is displayed while A-BPM is used.
Manual blood pressure measurement can be performed during
A-BPM waiting mode.
The measurement result for the manual blood pressure
measurement can be stored in the memory.
When A-BPM is stopped, the error code
the OLED and stored in the memory.
To start A-BPM
Step 1. Set the AUTO switch to "ON".
Step 2. The
started.
mark is shown on the OLED and LCD. A-BPM is
Note
70
E07 is displayed on