A&D TM-2441 Instruction Manual page 55

Automated self-blood pressure
The ASBP can specify up to six preset start time for the alarm.
When parameters for the ASBP program are stored, the ASBP
is started and the buzzer sounds at each start time. Press the
/ switch to perform a "1 scope" when the buzzer sounds.
"1 scope" consists of a set of blood pressure measurements and
interval times, which are repeated up to the number of times of the
measurement count. The last interval time is omitted.
Manual blood pressure measurement for the ASBP
When the
last "1 scope" and the next "1 scope", The "1 scope" is performed.
1 scope
T
T
Press the
switch to start "1 scope".
Start time of alarm
The ASBP is started at the same time when ASBP program is set.
(The ASBP becomes waiting mode until start time)
1 scope
T
T
/ switch is pressed in waiting mode between the
Blood pressure measurement
/
1 scope
T
T
Press the
to perform the manual-BPM.
Note
1 scope
Press the
switch to start "1 scope".
Start time of alarm
/ switch
35
ASBP
T T
/
1 scope
T T
T: Interval time
Time
Time