S-Bpm Waiting Mode - A&D TM-2441 Instruction Manual

1 scope
T T
Press the
Start time of alarm

6.2.2. S-BPM Waiting Mode

Operation mode and pressure value are displayed on the LCD during
S-BPM waiting mode.
#
The LCD will be hidden automatically after no-operation is continued
for few minutes. Even if the LCD is hidden, the manual blood
pressure measurement can be started when the
is pressed. When the START/STOP or EVENT switch is
pressed, the display resumes.
A "1 scope" consists of a set of blood pressure measurements and
interval times which are repeated up to the number of times of the
measurement count. The last interval time is omitted.
Clock mark
The S-BPM waiting mode is a state when blood pressure is not being
measured during the "interval time" and between the last "1 scope" and
next "1 scope".
Not measured
Press the /
/ switch to start "1 scope".
blinks on the LCD during a "1 scope" interval time.
1 scope
switch to stop "1 scope".
Program of the S-BPM
Pressurization value
Current time
36
T T
T: Interval time
/ switch
Time