A&D TM-2441 Instruction Manual page 71

Operation using switches
Step 1. Set the AUTO switch to "OFF".
Step 2. If the display is hidden, press the
START/STOP or EVENT switch to return to the waiting
mode display.
Step 3. While pressing and holding the START/STOP switch,
press and hold the EVENT switch until Sleep is displayed
on the OLED.
Step 4. Specify the sleep mode using the following switches.
If the sleep mode is "ON", proceed to step 5.
EVENT switch ................. Change the current parameter.
START/STOP switch ...... Decision, next item.
Step 5. Specify the start time and interval in up to six sections using
the following switches.
EVENT switch ................. Change the current parameter.
START/STOP switch ...... Decision, next item.
Step 6. Specify the start time and operation time of the automated
measurement using the following switches.
EVENT switch ................. Change the current parameter.
START/STOP switch ...... Decision, next item, end of settings.
Step 7. After completing the settings, the recorder returns to its waiting
mode.
Do not remove batteries while charging the settings.
If batteries are removed, input settings again.
Caution
51