8.4. S-BPM Programs
The initial settings can be configured using the following methods.
Using switches on the recorder.
Using a dedicated peripheral that is connected to the recorder
using the USB cable.
Procedure for operation using switches
Step 1. Set the AUTO switch to "OFF".
Step 2. While pressing and holding the
press and hold the START/STOP switch until
displayed on the LCD.
Step 3. Select S-BPM program using the following switches.
Program: OBP , AOBP, HBP, ANBP, ASBP
/
START/STOP switch ........ Decision, next item.
Step 4. Specify each item (Measurement count, Interval time, start time
and start time of alarm) using the following switches.
/
START/STOP switch ........ Decision, next item, end of settings.
Step 5. After completing settings, S-BPM clock is displayed.
Do not remove batteries while charging the settings.
If batteries are removed, input settings again.
switch ...................... Change the current parameter.
switch ...................... Change the current parameter.
/
switch,
Caution
58
is