Ecmp Hashing Fields Used For 7210 Sas Devices In Network Mode - Alcatel-Lucent 7210 SAS M Interface Configuration Manual

LAG
Table 12: LAG Hashing mechanism for services configured on 7210 SAS-Mxp devices
Services and Traffic Direction
IES (Multicast IP traffic)
IP interface (Network or SAP) to
IP interface (SAP)
Network Port IP
(Multicast IP traffic)
IP interface (Network or SAP) to
IP interface (Network)
NOTES:
1. VPLS service, SDP to SDP: Test has been performed only for VC label variation with the
2. In the LSR case, incoming labels are used for hashing.
3. 'Learnt' wherever mentioned corresponds to Destination MAC.
4. Source/Destination MAC refer to 'Customer Source/Destination MACs' unless otherwise
5. 'service_id' refers to the service id of the egressing VPLS/EPIPE/IES/VPRN service.
6. 'lag_index' refers to the Lag-IfIndex of the egressing lag.
7. 'encap_value' and 'service_vlan' are based on the inner/outer VLAN values of the
8. 'sap_index' is a value assigned uniquely for each SAP internally.

ECMP Hashing fields used for 7210 SAS devices in Network mode

Table 13: ECMP Hashing mechanism for services configured on 7210 SAS devices in
Page 68
ration Guide
Packet fields used for Hashing for different traffic types
IPv4 Multicast traffic: Software picks a port
interface IPv4 Multicast traffic: Source and Destination IP, Source and
Destination L4 ports, Ingress Port-Id.
same Tunnel label.
specified.
egressing LAG SAP.
7210 SAS M, T, X, R6, R12, Mxp Interface Configu-