Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 166

tunneling
Syntax [no] tunneling
Context config>port>ethernet>efm-oam
Description This command enables EFM OAM PDU tunneling. Enabling tunneling will allow a port mode Epipe SAP to
pass OAM frames through the pipe to the far end.
The no form of the command disables tunneling.
Default
no tunneling
egress-rate
Syntax egress-rate sub-rate [max-burst size-in-kbits]
no egress-rate
Context config>port>ethernet
Description
This command configures the rate of traffic leaving the network.
The no form of this command returns the value to the default.
Default no egress-rate
Parameters sub-rate — The egress rate in Kbps.
Values
max-burst size-in-kbits — ValuesThe maximum egress burst in kilobits (Kbits). 32 — 16384
encap-type
Syntax encap-type {dot1q | null| qinq}
no encap-type
Context config>port>ethernet
Description
This command configures the encapsulation method used to distinguish customer traffic on an Ethernet
access port, or different VLANs on a network port.
The no form of this command restores the default.
Default null
Parameters
dot1q — Ingress frames carry 802.1Q tags where each tag signifies a different service.
null — Ingress frames will not use any tags to delineate a service. As a result, only one service can be
configured on a port with a null encapsulation type.
qinq — This encapsulation type is specified for QinQ access SAPs.
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide
1 — 10000000
Interface Configuration
Page 161