Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 256

•
•
•
•
General Port Output Fields
Port ID
Admin State
Phy Link
Port State
Cfg MTU
Oper MTU
LAG ID
Port Mode
Port Encap
Port Type
SFP/MDI MDX
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide
Detailed Port Output Fields on page 261
Ethernet Output Fields on page 273
Ethernet-Like Medium Statistics Output Fields on page 291
Port Associations Output Fields on page 294
Label
The port ID configured or displayed in the slot/mda/port format.
Up — The administrative state is up.
Down — The administrative state is down.
Yes — A physical link is present.
No — A physical link is not present.
Up — The port is physically present and has physical link present.
Down — The port is physically present but does not have a link.
Ghost — A port that is not physically present.
None — The port is in its initial creation state or about to be deleted.
Link Up — A port that is physically present and has physical link
present.
Link Down — A port that is physically present but does not have a
link.
The configured MTU.
The negotiated size of the largest packet which can be sent on the port
specified in octets.
The LAG or multi-link trunk (MLT) that the port is assigned to.
network — The port is configured for transport network use.
access — The port is configured for service access.
Null — Ingress frames will not use tags or labels to delineate a ser-
vice.
dot1q — Ingress frames carry 802.1Q tags where each tag signifies
a different service.
QinQ — Encapsulation type specified for QinQ Access SAPs.
The type of port or optics installed.
GIGE — Indicates the GigE SFP type.
Interface Configuration
Description
Page 251