Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 164

• Priority tagged packet received with etype 0x8100 on a dot1q port configured with etype 0x9100 is
classified as a priority tagged packet and mapped to a dot1q:0 SAP (if configured) and the priority tag is
removed.
• Priority tagged packets received with etype 0x6666 (any value other than 0x8100) on a dot1q port con-
figured with etype 0x9100 is classified as null-tagged packet and mapped to a dot1q:0 SAP (if config-
ured) and the priority tag is retained and forwarded as expected.
• The maximum number of unique dot1q-etypes configurable per node is limited. The resources needed
for configuration of dot1q-etype is shared by the default dot1q-etype, default qinq-etype and user con-
figured values for qinq-etype. In other words, the number of unique dot1q-etypes allowed decreases, if
the number of unique qinq-etype configured is more. The converse is also true.
The no form of this command reverts the dot1q-etype value to the default.
Parameters 0x0600..0xffff — Specifies the Ethertype to expect.
Default
Values
duplex
Syntax duplex {full | half}
Context config>port>ethernet
Description
This command configures the duplex of a Fast Ethernet port when autonegotiation is disabled.
This configuration command allows for the configuration of the duplex mode of a Fast Ethernet port. If the
port is configured to autonegotiate this parameter is ignored.
Default
full
Parameters
full — Sets the link to full duplex mode.
half — Sets the link to half duplex mode.
efm-oam
Syntax efm-oam
Context config>port>ethernet
Description
This command configures EFM-OAM attributes.
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide
If the encap-type is dot1p, then the default is 0x8100.
If the encap-type is qinq, then the default is 0x8100.
<0x0600..0xffff> : [1536..65535] - accepts in decimal or hex
Interface Configuration
Page 159