Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 152

monitor-oper-group
Syntax monitor-oper-group name
no monitor-oper-group
Context config>port>ethernet
Description
Platforms Supported: 7210 SAS-M/T access-uplink mode. It is not supported in 7210 SAS-M and 7210
SAS-T network mode, 7210 SAS-Mxp, 7210 SAS-X, 7210 SAS-R6 and 7210 SAS-R12.
This command specifies the operational group to be monitored by the object under which it is configured.
The oper-group name must be already configured under the config>system context before its name is
referenced in this command.
The no form of the command removes the association from the configuration.
Default
no monitor-oper-group
Parameters
name — Specifies a character string of maximum 32 ASCII characters identifying the group instance.
Values
mac
Syntax mac ieee-address
no mac
Context config>port>ethernet
config>lag
config>eth-tunnel
Description
This command assigns a specific MAC address to an Ethernet port, Link Aggregation Group (LAG),
Ethernet tunnel.
Only one MAC address can be assigned to a port. When multiple mac commands are entered, the last
command overwrites the previous command. When the command is issued while the port is operational, IP
will issue an ARP, if appropriate, and BPDU's are sent with the new MAC address.
The no form of this command returns the MAC address to the default value.
Default
A default MAC address is assigned by the system from the chassis MAC address pool.
Parameters ieee-address — Specifies the 48-bit MAC address in the form aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff where
aa, bb, cc, dd, ee and ff are hexadecimal numbers. Allowed values are any non-broadcast, non-multicast
MAC and non-IEEE reserved MAC addresses.
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide
[32 chars max]
Interface Configuration
Page 147