Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 169

Ethernet Port Commands
The no form of the command disables PoE and PoE+ on this port. If PoE is disabled, the software does not
attempt to detect the characteristics of the PoE device connected to the port and not supply power to the port.
Parameters [plus] — The user can specify the parameter poe-plus to allow support of 802.3at (Type-2) high power
devices to be connected to the port.
oper-group
Syntax no oper-group
oper-group name
Context config>port>ethernet
config>lag
Description
Platforms Supported: 7210 SAS-M/T access-uplink mode. It is not supported in 7210 SAS-M and 7210
SAS-T network mode, 7210 SAS-Mxp, 7210 SAS-X, 7210 SAS-R6 and 7210 SAS-R12.
This command associates the context to which it is configured to the operational group specified in the
group-name. The oper-group group-name must be already configured under config>system context before
its name is referenced in this command.
The no form of the command removes the association.
Parameters
name — Specifies a character string of maximum 32 ASCII characters identifying the group instance.
Values
qinq-etype
Syntax qinq-etype 0x0600..0xffff
no qinq-etype
Context config>port>ethernet
Description
This command configures the Ethertype used for Q-in-Q encapsulation.
When the qinq-etype is configured to a value other than 0x8100 (the default value used for etype match) on
a port, the outermost tag in the received packet is matched against the configured value and the inner tag's
etype is matched against 0x8100, if there is a match then it is treated as a QinQ packet and the outer VLAN
ID and inner VLAN ID is used to match against the configured Q1.Q2 SAPs on the port to find the QinQ
SAP the packet should be matched to. If only the outermost tag's etype matches the qinq-etype configured
on the port and the VLAN ID matches any of the Q1.* SAP configured on the port, the packet is processed
in the context of that SAP. If the outermost tag's etype does not match the configured qinq-etype, then the
packet is considered to be a untagged packet.
NOTES:
• This command takes effect only for access ports and hybrid ports. On hybrid ports, it applies to all traf-
fic (that is, traffic mapped to SAPs and network IP interfaces). It is not supported for network ports.
Page 164
Guide
[32 chars max]
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration