Booting A 7210 Sas-X From The Network - Alcatel-Lucent 7210 Installation Manual

Initializing the System and Downloading Software

Booting a 7210 SAS-X From the Network

You will need the following:
•
•
•
•
•
Prepare the set up as shown in the diagram above. Ensure that the console settings are set as shown
in Console Connection on page
When you are done, power on the 7210 SAS-X.
Using the uplink port to boot 7210 from the network:
Alcatel 7xxx Boot ROM. Copyright 2000-2010 Alcatel-Lucent.
All rights reserved. All use is subject to applicable license agreements.
Build: X-2.0.S126 on Thu Sep 2 23:10:39 IST 2010 by builder
Version: 0x1D
Doing DRAM test first stage
COLD boot on processor #
Doing DRAM test second stage
Board Serial Number is 'NS1035F0181'
Disabling RML interrupt done
Build V-2.0.S126 bootrom/hops 7xxx
Built on Thu Sep 2 22:56:00 IST 2010 by builder in /builder/2.0S/panos/main
?Attempting to load from file cf1:/boot.tim
Version L-2.0.S141, Sat Sep 25 22:42:06 IST 2010 by builder in /builder/2.0S/panos/
main
text:(4561585-->36913680) + data:(903350-->3359264)
Starting at 0xe000000...
Since the router does not ship with a BOF, it will show the default settings.
Looking for cf1:/bof.cfg ... not found
Could not find bof.cfg on any of the local drives.
Default Settings:
-------------------------------------------------------------------------------------
------------
Contents of Boot Options File on cf1:
#eth-mgmt Port Settings:
Page 46
A FTP server
TiMOS image
A PC with a serial port and Hyperterminal
Cable that connects the console port of 7210 SAS-X to the serial port of PC
A network cable to connect the 7210 unit to the network
56.
7210 SAS-X Installation Guide