Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 321

LAG Commands
Up-Link-Count
MC Act/Stdby
Sample Output
A:ALA-48# show lag
===============================================================================
Lag Data
===============================================================================
Lag-id
-------------------------------------------------------------------------------
1
2
3
4
5
6
-------------------------------------------------------------------------------
Total Lag-ids: 6
===============================================================================
A:ALA-48#
On SAS-K:
Detailed LAG Output — The following table describes detailed LAG output fields.
Detailed LAG Output Fields
LAG ID
Adm
Port Threshold
Thres. Last
Cleared
Dynamic Cost
Configured
Address
Hardware Address
Hold-Time Down
Page 316
Guide
Label
The number of ports that are physically present and have physical links
present.
Member port is selected as active or standby link.
Adm Opr
up up
up up
up up
up up
up up
up up
Single Chassis: 6
Label
The LAG or multi-link trunk (MLT) that the port is assigned to.
Up — The LAG is administratively up.
Down — The LAG is administratively down.
If the number of available links is equal or below this number, the
threshold action is executed.
The last time that keepalive stats were cleared.
The OSPF costing of a link aggregation group based on the available
aggregated, operational bandwidth.
The base chassis Ethernet MAC address.
The hardware address.
The timer, in tenths of seconds, which controls the delay between
detecting that a LAG is down and reporting it to the higher levels.
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Description
Port-Threshold Up-Link-Count
0 2
0 2
0 2
0 2
0 2
0 2
MC Act: 0
Description
MC Act/Stdby
N/A
N/A
N/A
N/A
N/A
N/A
MC Stdby: 0