Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 327

LAG Commands
LACP Status
Lag-id
Port-id
Adm
Act/Stdby
Opr
Primary
Sub-group
Forced
Priority
Fld-port
Sample Output
Initial output without subgroups:
-------------------------------------------------------------------------------
Port-id
-------------------------------------------------------------------------------
1/1/3
32768
1/1/5
32768
2/1/3
32768
2/1/4
32768
-------------------------------------------------------------------------------
Once subgroups are configured:
-------------------------------------------------------------------------------
Port-id
Page 322
Guide
Label
The service associated with the LAG.
The LAG or multi-link trunk (MLT) that the port is assigned to.
The port ID configured or displayed in the slot/mda/port format.
The administrative state of the port/KAG. Displays UP to indicate
LAG/port is administratively UP (no shutdown) state and displays
Down to indicate LAG/port is administratively Down (shutdown)
state.
Indicate if the member port of the LAG is active link or standby link.
Operational state of the LAG/port.
Indicates if the port is a primary member port of the LAG.
Displays the sub group the port belongs to.
Indicates if the ports of the subgroup were forced to be the active/
standby member ports by the user.
The user configured priority for the port.
Indicates the active member port of the LAG which is used for
flooding BUM traffic. On 7210 SAS-R6 and 7210 SAS-R12, in a
VPLS service, while egressing on a lag sap, a single active member
port of the lag is used to flood the BUM traffic received in the service.
Adm Act/Stdby Oper
up active
yes
up active
no
up active
no
up active
no
Adm Act/Stdby Oper
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Description
Primary Sub-grp Forced Prio
up yes
up
up
up
Primary Sub-grp Forced Prio
Fld-Port
1
1
1
1
Fld-Port
-
-
-
-