Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 191

TDM Commands (Applicable to 7210 SAS-M when using the CES MDA)
framing (E-1)
Syntax framing {no-crc-g704 | g704 | e1-unframed}
Context config>port>tdm>e1
Description
This command specifies the E-1 framing to be used for the port.
Default e1-unframed
Parameters g704 — Configure the E-1 port for G.704 framing.
no-crc-g70 — Configures the E-1 for G.704 with no CRC4.
e1-unframed — Specifies E1 unframed (G.703) mode for E1 interfaces. E1 unframed mode is only
applicable if the encapsulation type is set to 'cem'.
idle-cycle-flag
Syntax idle-cycle-flag {flags | ones}
Context config>port>tdm>ds1>channel-group
config>port>tdm>ds3
config>port>tdm>e1
config>port>tdm>e1>channel-group
config>port>tdm>e3
Description This command configures the value that the HDLC TDM DS-0, E-1, E-3, DS-1, or DS-3 interface transmits
during idle cycles. For ATM ports/channels/channel-groups, the configuration does not apply and only the
no form is accepted.
The no form of this command reverts the idle cycle flag to the default value.
Default
flags (0x7E)
no flags (ATM)
Parameters flags — Specifies that 0x7E is used as the idle cycle flag.
ones — Specifies that 0xFF is used as the idle cycle flag.
idle-payload-fill
Syntax idle-payload-fill {all-ones | pattern pattern}
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description
This command defines the data pattern to be transmitted when the circuit emulation service is not
operational or temporarily experiences under-run conditions.This command is only valid for cesopsn
services.
Page 186
Guide
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration