Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 125

Card, MDA, and Port Command Reference
Port Ethernet CRC Monitoring Commands
config
Port Ethernet 802.1x Commands
config
Page 120
Guide
— connection-type
— down-on-internal-error
— no down-on-internal-error
— duplex
— encap-type
— no encap-type
— hold-time
— no hold-time
— no ip-mtu
— [no]
— mac
— no mac
— mode
— no mode
— monitor-oper-group
— no monitor-oper-group
— mtu
— no mtu
— multicast-ingress
— no multicast-ingress
— no loopback
— no oper-group
— oper-group
— no poe
— poe
— qinq-etype
— no qinq-etype
— [no]
— speed
— [no]
— [no] port {port-id}
— ethernet
— crc-monitor
— [no] port {port-id}
— ethernet
— dot1x
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
connection-type (supported only on 7210 SAS-Mxp devices)
{full | half}
{dot1q | null | qinq}
{[up hold-time up] [down hold-time down] [seconds| centiseconds]}
mtu-bytes
lacp-tunnel
ieee-address
{access [uplink] network| hybrid}
name
mtu-bytes
{l2-mc | ip-mc}
{internal} [service svc-id sap sap-id src-mac SA dst-mac DA]
name
[plus]
0x0600..0xffff
report-alarm [signal-fail] [remote] [local]
{10 | 100 | 1000}
shutdown
— sd-threshold threshold [multiplier multiplier]
— sf-threshold threshold [multiplier multiplier]
— window-size seconds