Alcatel-Lucent 7210 SAS M Interface Configuration Manual page 141

MDA Commands
The no form of this command deletes the MDA from the configuration. The MDA must be administratively
shut down before it can be deleted from the configuration.
Default MDA 1 is auto-equipped and auto-provisioned by default during bootup.
Parameters
mda-type — The type of MDA selected for the slot postion.
Values
sync-e
Syntax [no] sync-e
Context config>card>mda
Description
This command enables Synchronous Ethernet on the Ethernet ports that support Synchronous Ethernet.
When Synchronous Ethernet is enabled, the timing information is derived from the Ethernet ports.
Synchronous Ethernet is supported for both Ethernet SFP ports and fixed copper ports. It is highly
recommended to use copper port only for distribution of synchronous ethernet and not as a reference.
Refer to the 7210 SAS Basic System Configuration Guide for more information on Synchronous Ethernet.
Default no sync-e
Page 136
Guide
7210 SAS-M – m2-xfp |m4-ds1-ces (The logical MDA with fixed ports is auto-
provisioned)
7210 SAS-X, 7210 SAS-T, 7210 SAS-Mxp – The logical MDA with fixed ports is auto-
provisioned
7210 SAS-R6, 7210 SAS-R12 – The logical MDA (which is named based on the type of
IMM) is auto-provisioned
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration