Available Fonts; Esc/P Emulation - Fuji Xerox ApeosPort-VII C4421 User Manual

19 Appendix
[Programming]
Check or change the value set for the emulation mode item number.
 Enter the feature's item number to [Item Number] to display the current setting.
 To change the setting, enter the new value to [New Value] and then tap [Save].
[Store / Delete Programming]
Stores the current selections to [Custom Settings] or deletes stored memories.
[Default Programming]
Set the default setting of when the device activates.
Select [Factory Defaults] or select the number of stored setting from [Custom Settings].

Available Fonts

See [Font List] and [PCL Font List] to check the available fonts.
User-defined Characters
You can use user-defined characters in the ESC/P mode.
User-defined characters are registered as bitmap fonts, and the settings retain after the
device is turned off.

ESC/P Emulation

Emulation Print Features
 Pages per Side
The Pages per Side feature reduces the size of multiple-sheet documents and prints them
on a single sheet of paper.
In the ESC/P mode, 2 Up can be used.
 Form Overlay
In the ESC/P mode, you can register an original form on the device, and overprint the form
on a printout. ESC/P mode allows using forms of ESC/P. Use the control panel to specify the
form to overlay.
 Barcodes
In the ESC/P mode, you can use barcodes. Available barcodes are as follows:
 Code39
 EAN-8
 EAN-13
 Code 128
 NW7 (CODABAR)
 ITF (Interleaved 2 of 5)
 IDF (Industrial 2 of 5)
 Post (Japanese postal Customer Code)
 QR Code
480