[Reduce / Enlarge]; [Slight Reduction]; [Pages Per Side]; [Lighten / Darken] - Fuji Xerox ApeosPort-VII C4421 User Manual

[Reduce / Enlarge]

Specify a copy ratio.
When you select [Auto %], the device set the appropriate copy ratio based on the original
and paper sizes.
When you select [More Options], you can enter a ratio directly or can specify reduction/
enlargement ratios for the width and length individually.
 When [More Options] > [Proportional %] is selected
You can select a ratio from the standard copy ratios, or can enter a ratio directly.
 When [More Options] > [Independent X - Y%] is selected
You can specify reduction/enlargement ratios for the width and length individually.
 When [More Options] > [Calculator %] is selected
You can specify values for the length and width individually.
If you specify both the size of original and the desired copy size, the copy ratios for the
length and width are calculated automatically.
Note

The values entered in [Original Size] and [Copy Size] are used to calculate ratios, and do not reflect a scan size
for the original or the paper size. Be sure to specify a scan size for the original.

[Slight Reduction]

The device reduces the specified copy ratio slightly to copy the complete image onto the
paper.
Important
 Even when you select [Slight Reduction], the edges may be erased. If you do not want to erase the edges of
the original, set the edge erasing amount to 0 mm. Setting to 0 mm may make the edges of the copied sheet
dirty. You can set the edge erasing amount in [Edge Erase].

[Pages per Side]

This feature allows you to copy two, four, or eight pages of an original together onto a
single sheet of paper. It also allows you to specify the layout or orientation of the pages in
copying.
Note
 When you set [Pages per Side], [Auto %] is automatically selected in [Reduce / Enlarge]. The device
automatically sets the copy ratio and makes copies of the images so that they fit on the selected paper.

When you deselect [Auto %] in [Reduce / Enlarge] (when you select another copy ratio), image loss may
occur depending on the image size of the original.

When [Image Shift] is set, the image shift amounts are applied to the whole original. For this reason, image
loss may occur depending on the image size of the original.

When [Edge Erase] is set, the edge erase amounts are applied to each original page.

Select a tray other than [Auto Select] in [Paper Supply]. If [Auto Select] is selected in [Paper Supply], a tray
specified in [Auto Paper Off] is automatically selected. Change the setting as necessary. For information on
[Auto Paper Off], refer to "[Auto Paper Off]" (P.266).

[Lighten / Darken]

This feature allows you to select a copy-density level.
Features List
131