Wi-Fi Connection - Fuji Xerox ApeosPort-VII C4421 User Manual

Wi-Fi Connection

Wi-Fi Connection Setup Methods
You can set the Wi-Fi connection in two ways using the touch screen of the device:
 Automatic connection
 Manual connection
There are two types of automatic connection methods: WPS (push button method) and
WPS (PIN code method). The device supports both of the methods.
 For WPS (push button method)
Configure the settings on the control panel, and then press the WPS button on your
wireless LAN access point.
 For WPS (PIN code method)
Enter the PIN code assigned to the device into the wireless LAN access point.
These methods are available only when the access point supports WPS.
Reference

For information on the WPS operation on the access point or wireless router, refer to the manual supplied
with the access point.
Configuring Wi-Fi Connection Settings
Note
 Rebooting the device may be required depending on the settings. When a message is displayed on the
screen, follow the message and reboot the device.
1
Enter the system administration mode and tap [Device] on the Home screen.
Reference

For the detailed procedure, refer to "Login to Authentication Mode" (P.77).
2
Tap [Connectivity & Network Setup].
3
Tap [Wireless LAN Settings].
Note

If [Wireless LAN Settings] does not appear, the kit is not attached properly. Review the installation process.
Reference

For details, refer to "Installing/Removing Wireless LAN Kit" (P.461).
4
Tap [Common Settings].
5
Tap [Enabled], and then tap [OK].
6
When you connect to an access point, which uses RADIUS server authentication
(IEEE802.1X authentication), the certificate setting in CentreWare Internet Services is
required. Proceed to "Connecting to a High Security Network via CentreWare Internet
Services" (P.44) and configure the required settings.
When you connect to an access point, which does not require certificates, proceed to step 7.
7
Tap [Wi-Fi Connection Settings].
WLAN Network Configuration
41