Reconfiguring The System Memory; Replacing A Pci Or Graphics Card; Figure 4-15 Installing A Dimm - Sun Microsystems Ultra 20 User Manual

6. Insert the DIMM into the slot.
Using both thumbs, press the DIMM straight down into the DIMM slot until both ejector
levers click, locking the DIMM in the DIMM slot.
The DIMMs must be inserted evenly, straight down along the DIMM slot until
■
they are locked into place.
The DIMM is seated when you hear a click and the DIMM ejector levers are in the
■
vertical position.
FIGURE 4-15
7. Repeat
8. Replace the left-side access panel.
4.5.4.4

Reconfiguring the System Memory

The system automatically detects the amount of memory installed. Run the BIOS
setup to view the new value for total system memory, and make a note of it.
4.5.5

Replacing a PCI or Graphics Card

This procedure describes how to install a typical PCI card (including the host bus
adapter) or graphics card. PCI and graphics cards might vary in the way in they are
installed in the system.
4-22 Sun Ultra 20 Workstation User Guide • August 2006
Installing a DIMM
Step 4 through Step 6 for each DIMM that you want to replace.