Sun Microsystems Ultra 20 User Manual page 118

9. Copy the xorg configuration file to the /etc/X11 directory by typing.
# cp /xorg.conf.new /etc/X11
10. Rename the file from xorg.conf.new to xorg.conf.
# cd /etc/X11
# mv xorg.conf.new xorg.conf
11. Type the following commands to rename the s99dtlogin file:
# cd /ect/rc2.d
# mv s99dtlogin S99dtlogin
12. Reboot the workstation.
Note – Both graphics cards are available as display devices, but you must configure
them correctly. Configuring the graphics cards is an advanced operation. Refer to the
README for the NVIDIA drivers for information specific to your operating system
B.3 Enabling the Onboard ATI Graphics
Controller Before Solaris Installation
To enable the ATI graphics controller along with a PCI Express x16 3D graphics card
after the Solaris 10 Operating System image was removed from the workstation, but
before you reinstall the OS:
1. Reboot the workstation and press the F2 key at the Solaris logo screen.
The BIOS Setup menu displays.
2. Make changes in the BIOS to enable the onboard ATI graphics controller:
a. Select PnP/PCI Configurations in the main menu.
b. Select the Init Display First option.
B-4 Sun Ultra 20 Workstation User Guide • August 2006