4.3
Opening the Workstation
Caution – Before you proceed, turn off your system and all of the peripherals
connected to it. Refer to
4.3.1
Removing the Access Panel
You must remove the left-side access panel to gain access to the system's internal
components.
1. Turn off the system and all of the peripherals connected to it.
2. Loosen the two captive thumbscrews located on the edge of the left-side panel
closest to the back panel.
3. Slide the panel toward the back of the workstation. Tilt the top edge of the panel
out and then up to remove it from the chassis.
FIGURE 4-1
4-4
Sun Ultra 20 Workstation User Guide • August 2006
Section 4.2.2, "Preinstallation Instructions" on page
Removing the Side Panel
4-2.