Sun Microsystems Ultra 20 User Manual page 94

6. Replace the left-side access panel.
7. Connect cables to the front-panel connectors as necessary.
Note – These connectors are not keyed. Make sure that you reinstall them in the
proper orientation. Be careful not to bend the pins.
4.5.10 Replacing System Cables
The following system cables have a connector at each end, and so can be removed or
installed by the customer. All other cables are permanently attached to a system
component at one end and must be removed or replaced along with the component.
See
FIGURE 4-33
Front I/O board cables:
■
■
■
■
■
DVD cables:
■
■
■
SATA cables (SATA backplane)
■
4-42 Sun Ultra 20 Workstation User Guide • August 2006
for locations of connectors.
Audio cable
USB cable
IEEE 1394 cables
Power button/LED cable
IDE cable
Audio cable