Removing the SATA Backplane
FIGURE 4-8
5. Unfasten the SATA backplane from the chassis (see
Using a No. 2 Phillips screwdriver, remove the four screws that secure the SATA
backplane to the chassis. Set the screws aside in a container.
6. Slide the SATA backplane out of the hard drive bracket and set it aside.
7. Proceed to
Section 4.5.2.2, "Installing the SATA Backplane" on page 4-14
the new SATA backplane.
).
FIGURE 4-8
Chapter 4 Maintaining the Workstation
to install
4-13