Replacing A Dvd Drive; Removing A Dvd Drive - Sun Microsystems Ultra 20 User Manual

5. Connect and route the cables (see
a. Connect the SATA interface cables to the SATA backplane connector.
b. Connect the power supply power cable to connector P4.
Refer to the cabling diagram in the service label on the side of the chassis for
information on cable routing.
6. Slide the hard drive bracket into the hard drive bay until the latch clicks.
You are finished replacing the SATA backplane.
7. Install all hard drives into the hard drive bracket.
See Section 4.5.1.2, "Installing a Hard Disk Drive" on page
8. Inspect the SATA backplane and the related component fasteners.
Be sure that the hard drive handles are flush and locked.
■
Be sure that the hard drives are seated the backplane connector.
■
9. Inspect the SATA backplane and the related component cabling.
Be sure that the power cable is seated in the SATA backplane.
■
Be sure that the SATA interface cable is seated in the SATA backplane connector.
■
Be sure that the interface cable is routed through the routing clip on the SATA
■
backplane cover.
10. Replace the left-side panel of the workstation.
4.5.3

Replacing a DVD Drive

4.5.3.1

Removing a DVD Drive

To remove a DVD drive:
1. Remove any media in the DVD drive.
2. Turn off the power button on the back of the system and power off all of the
peripherals connected to the workstation.
3. Remove the left-side access panel.
4. Remove the front bezel (see
).
FIGURE 4-9
Section 4.3.2, "Removing the Front Bezel" on page
Chapter 4 Maintaining the Workstation
4-10.
4-5).
4-15