Postinstallation Instructions - Sun Microsystems Ultra 20 User Manual

4.2.3

Postinstallation Instructions

Perform the following steps after installing a workstation component:
1. Ensure that all of the components are installed as described in the step-by-step
instructions.
See Section 4.5, "Component Replacement Procedures" on page
2. Reinstall any PCI cards or peripherals that you had previously removed.
See Section 4.5, "Component Replacement Procedures" on page
3. Reinstall the system's left-side panel and front bezel.
See Section 4.3, "Opening the Workstation" on page
4. Connect all external cables to the system.
5. Power on the system.
See Section 1.4.1, "Powering On the Workstation" on page
Caution – If the left-side panel and hard disk drives were removed, do not operate
the workstation for more than ten minutes. Improper cooling airflow might damage
the system's components.
4-8.
4-8.
4-4.
1-8.
Chapter 4 Maintaining the Workstation 4-3