Sun Microsystems Ultra 20 User Manual page 119

c. Change the display order so that PCI is the first display option.
This ensures that the ATI graphics controller is enabled as the primary output
device. If a 3D card is installed, it functions as the secondary device.
d. Press the F10 key to save your changes and exit.
e. Save your data and exit the BIOS.
3. Connect a second monitor to the onboard video connector.
4. Reboot the workstation and install the Solaris 10 operating system.
5. After the operating system installation is complete, open a terminal window and
log into the workstation as superuser.
6. Type the following commands:
# /etc/rc2.d/S99dtlogin stop
# /usr/X11/bin/Xorg -configure
Xorg probes the hardware on the system and create an xorg configuration file called
xorg.conf.new in the root directory.
7. Copy the xorg.conf.new file to the /etc/X11 directory by typing:
# cp /xorg.new /etc/X11
8. Rename the file from xorg.conf.new to xorg.conf:
# cd /etc/X11
# mv xorg.conf.new xorg.conf
9. Reboot the workstation.
Note – Both graphics cards are available as display devices, but you must configure
them correctly. Configuring the graphics cards is an advanced operation. Refer to the
README for the NVIDIA drivers for information specific to your operating system
Appendix B Setting Up Multiple Monitor Access B-5