4
C H A P T E R
Maintaining the Workstation
This chapter provides instructions on how to add, replace and configure the
components in the workstation after it is set up. The following sections are included
in this chapter:
Section 4.1, "Tools and Supplies Needed" on page 4-1
■
Section 4.2, "Installation Precautions" on page 4-1
■
Section 4.3, "Opening the Workstation" on page 4-4
■
Section 4.4, "Location of Components" on page 4-7
■
Section 4.5, "Component Replacement Procedures" on page 4-8
■
4.1
Tools and Supplies Needed
Phillips screwdriver
■
Flat-head screwdriver
■
Antistatic wrist strap (shipped with every CRU)
■
4.2
Installation Precautions
Before removing the system's left-side access panel, read the following sections.
These sections contain important ESD precautions, along with preinstallation and
postinstallation instructions.
4-1