4.5.2.2
Installing the SATA Backplane
To install the SATA backplane:
1. Open the chassis.
2. Remove the new SATA backplane from its packaging.
3. Slide the SATA backplane under the hard drive bracket.
Position the screw holes over the holes in the chassis.
FIGURE 4-9
4. Fasten the SATA backplane to the hard drive bracket.
Using a No. 2 Phillips screwdriver, install the four screws that secure the SATA
backplane to the hard drive bracket. Torque the screws to inch pounds.
4-14
Sun Ultra 20 Workstation User Guide • August 2006
Installing the SATA Backplane