Table of Contents
Advertisement
Maintenance
Caution
If you leave the key in the ignition switch, someone
could start the engine. Accidental starting of the
engine could seriously injure you or other
bystanders.
Remove the key from the ignition switch before
you do any maintenance.
Service Interval Chart
Service
8 Hrs 25 Hrs
Operation
Grease fittings
Inspect for leaks
Chipped
surfaces–paint
Greasing and Lubrication
Service Interval/Specification
Grease all fittings every 8 operating hours (Fig. 26). Note
that in most cases the grease fittings are located in the
center of every pivot pin. Also, grease the fitting in the
swing cylinder pivot pin, located under the seat column,
under the backhoe (this location is not shown in Figure 26).
Grease all fittings immediately after every washing.
Grease Type: General-purpose grease
How to Grease
1. Stop the engine and remove the key.
Storage
Service
X
X
X
X
X
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting.
4. Pump grease into the fittings until grease begins to ooze
out of the bearings.
5. Wipe up any excess grease.
Storage
1. Before long term storage wash the attachment with mild
detergent and water to remove dirt and grime.
2. Apply grease to all grease fittings.
3. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that are damaged or worn.
4. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
5. Store the attachment in a clean, dry garage or storage
area. Cover it to protect it and keep it clean.
17
m-?
Figure 26
Advertisement
Table of Contents
