Setting The Tape Drive's Scsi Id - Nortel CallPilot Installation And Configuration Manual
Hide thumbs
Also See for CallPilot:
- Install manual (286 pages) ,
- Administrator's manual (250 pages) ,
- User manual (182 pages)
Table of Contents
Advertisement
October 2000
Setting the tape drive's SCSI ID
Introduction
This section describes how to set the tape drive's SCSI ID.
ATTENTION
Note: The tape drive discussed in this section is the Tandberg SLR5 tape drive
(NTRH9038). This is currently the only supported tape drive.
To set the tape drive SCSI ID
The SCSI ID setting is located on the back of the tape drive. See the diagram that
follows.
Note: The appearance and size of the tape drive cabinet is subject to change. The
diagram is an example of the key components.
To change the SCSI ID, use the blade of a screwdriver to press either the plus (+) or
minus (–) button on the SCSI ID thumbwheel switch. Set the SCSI ID to 5.
Part 2: 201i Server Hardware Installation
To recognize the new settings, power down the tape drive before
changing the SCSI ID.
SCSI ID
thumbwheel
switch
Internally
terminated
Installing the server and connecting the peripherals
SCSI
interface
connectors
AC power
receptacle
G101183
93
Advertisement
Table of Contents
