Nortel CallPilot Installation And Configuration Manual page 92

Installing the server and connecting the peripherals
To set the CD-ROM drive's DIP switches
Set the CD-ROM drive's DIP switches as described in the following table:
DIP switch
1
2
3
4
5
What's next?
If you are also installing a tape drive, set the tape drive's SCSI ID (see page 93);
otherwise, set the CD-ROM drive's device termination (see page 94).
92
Description Setting
Parity ON
Termination Note: For more information about daisy chaining
SCSI devices, see "Setting SCSI device
termination" on page 94.
If the CD-ROM drive is the first and only device,
set this switch to ON.
If the CD-ROM drive is the first device and daisy
chained with the tape drive, set this switch to OFF.
Test OFF (for factory use only)
Block OFF
Eject OFF
Note: If this switch is set to ON, the eject button
on the CD-ROM drive is disabled. To eject the
CD-ROM from the drive, a software eject
command must be sent over the SCSI bus.
Standard 1.0
CallPilot