Nortel CallPilot Installation And Configuration Manual page 41

October 2000
8. Install the MPC cards (see page 103).
9. Connect the 201i server and devices as follows:
Connect the monitor, keyboard, and mouse to the 201i server faceplate (see
page 105).
Connect the CD-ROM and tape drives to the intermediate SCSI cable (see
page 106).
Connect the multi I/O cable to the ELAN and CLAN network hubs (see
page 110).
Note: If more than 3 m (10 ft) of multi I/O cable is required, use the
supplied RJ-45 female-to-female gender change jacks to attach additional
cable. Up to 76.2 m (250 ft) of cable length is supported.
Connect the modem to the multi I/O cable (see page 113).
Connect the power cords for all devices.
Power up the devices.
10. Complete the installation of the 201i server as follows:
Connect the intermediate SCSI cable to the 201i server faceplate.
Close the lock latches on the 201i server.
Boot the 201i server to Windows NT.
See page 115.
When you are finished, continue with Part 3 of this binder.
Part 2: 201i Server Hardware Installation
Installing the server and connecting the peripherals
41