Nortel CallPilot Installation And Configuration Manual page 51

October 2000
Two pairs of screw holes are provided for connecting the secondary backplane
connector to the 201i server's stiffening cage. The outside pair provides the
Meridian 1 spacing. The inside pair provides the Option 11C or Option 11C Mini
spacing.
See the following diagram:
Required equipment
To move the secondary backplane connector, you need a Phillips No. 1 screwdriver.
A pair of needle-nosed pliers can also be helpful for removing the connector pin.
Part 2: 201i Server Hardware Installation
Installing the server and connecting the peripherals
Screw Secondary
location for backplane
Meridian 1 connector
Screw location
for Option 11C
Connector
pin socket
Screw location
for Option 11C
Screw location
for Meridian 1
Stiffening
cage
Secondary
backplane
connector
front view
G101443
51