Installing The Intermediate Scsi Cable For Option 11C - Nortel CallPilot Installation And Configuration Manual

Installing the server and connecting the peripherals
Installing the intermediate SCSI cable for
Option 11C
Introduction
Before you can connect a CD-ROM or tape drive to the 201i server, you must install
the intermediate SCSI cable. The intermediate SCSI cable routes the SCSI
connection away from the 201i server faceplate so that an external SCSI device can
remain permanently connected.
Note: If you are installing the 201i server in a Meridian 1, go to page 60. For Option
11C Mini, go to page 73.
Cable description
The connector on the intermediate SCSI cable that attaches to the 201i server
faceplate is a low-profile right-angle connector. This allows the cable to be attached
with the Option 11C cabinet covers on.
The SCSI device connector end is equipped with a bracket assembly. This bracket
assembly is attached to the Option 11C below the card cage.
Option 11C SCSI cable NTRH1407
66
Standard 1.0
201i server
faceplate
connector
Drain wire
SCSI
connector
Bracket
assembly
G101553
CallPilot