Installing The Ntrh3501 Backplane Cable - Nortel CallPilot Installation And Configuration Manual
Hide thumbs
Also See for CallPilot:
- Install manual (286 pages) ,
- Administrator's manual (250 pages) ,
- User manual (182 pages)
Table of Contents
Advertisement
October 2000
Installing the NTRH3501 backplane cable
Introduction
The backplane (tip and ring) cable supplied with the 201i server (NTRH3501) is
required for 100Base-T Ethernet CLAN operation. This cable offers more network
throughput than the cable you just removed from the Meridian 1.
When installed, this cable completes the connection between the left slot, the I/O
panel on the rear of the switch, and the multi I/O cable on the 201i server.
Backplane (tip and ring) cable
The following diagram shows the NTRH3501 backplane (tip and ring) cable:
Backplane (tip and ring) cable NTRH3501
Part 2: 201i Server Hardware Installation
Installing the server and connecting the peripherals
UP 1
UP 2
UP 3
G101546
57
Advertisement
Table of Contents
