Nortel CallPilot Installation And Configuration Manual page 35

October 2000
The following table describes how the SCSI connection is achieved:
Switch platform
Large Meridian 1
systems
Option 11C
Option 11C Mini
ATTENTION
Part 2: 201i Server Hardware Installation
Description
For large Meridian 1 systems (such as Option 51), the
intermediate SCSI cable is routed to the I/O panel on
the rear of the IPE shelf housing the server. Another
cable coming from the I/O panel establishes the
connection to the SCSI devices.
This is described in "Installing Meridian 1 hardware
and cables" on page 47
When the 201i server is installed in an Option 11C
cabinet, an intermediate SCSI cable is routed through
the wiring channel to a bracket assembly that is
attached to the base of the cabinet cover. The SCSI
device connects to the SCSI connector on the bracket
assembly.
This is described in "Installing Option 11C cables" on
page 65.
When the 201i server is installed in an Option 11C
Mini cabinet, the SCSI cable is routed from the 201i
server faceplate directly to the SCSI device.
If the Option 11C Mini is equipped with a Fiber
Routing Guide, you must remove it before you can
install the SCSI cable.
This is described in "Installing Option 11C Mini
cables" on page 71.
Due to a Windows NT restriction, you must connect external
SCSI devices before the 201i server is started. External SCSI
devices cannot be disconnected while the 201i server is
powered on.
If a SCSI device is not connected before the 201i server is started,
or a device is disconnected after the 201i server is started, you must
reconnect the device and restart the system.
About the 201i server
.
35