Connecting The Cd-Rom And Tape Drives - Nortel CallPilot Installation And Configuration Manual

Installing the server and connecting the peripherals

Connecting the CD-ROM and tape drives

Introduction
You can connect the CD-ROM, tape drive, or both to the intermediate SCSI cable
that you installed earlier.
Before you begin
Before you can connect the CD-ROM or tape drive, ensure that you have completed
the following tasks:
1. Install the intermediate SCSI cable:
For Meridian 1, see "Installing the SCSI cables for Meridian 1" on page 60.
For Option 11C, see "Installing the intermediate SCSI cable for
Option 11C" on page 66.
For Option 11C Mini, see "Installing the NTRH3502 SCSI cable for
Option 11C Mini" on page 73.
2. Set the SCSI ID and device termination settings.
See "Setting the CD-ROM drive's SCSI ID and DIP switches" on page 91.
See "Setting SCSI device termination" on page 94.
Selecting the procedure for your switch
IF you are working with
a large Meridian 1 switch
(such as Option 51)
Option 11C
Option 11C Mini
106
THEN see
"To connect the CD-ROM and tape drives to the
201i server (Meridian 1)" on page 107.
"To connect the CD-ROM and tape drives to the
201i server (Option 11C)" on page 108.
"To connect the CD-ROM and tape drives to the
201i server (Option 11C Mini)" on page 109.
Standard 1.0
CallPilot