Overview - Nortel CallPilot Installation And Configuration Manual

October 2000

Overview

Introduction
This section provides a high-level overview of the requirements and procedure for
installing the 201i server.
Prerequisites
Switch slot requirements
The 201i server occupies physical and electrical slots. The 201i server must be
installed in two peripheral equipment slots as follows:
Option 11C: in slots 1 through 9 in any Option 11C cabinet
Option 11C Mini: in a pair of consecutive slots in any cabinet
The 201i server cannot be installed in slots 0 or 4 because these slots are
dedicated to other cards. For more information about cards and slots, refer to
the Option 11C Mini documentation.
Meridian 1 tiered systems: in slots 0 through 14
Ensure that both slots have electrical backplane connectivity.
Meridian 1 I/O panel connections
On the Meridian 1, the 201i server requires two connections from the IPE slots to the
I/O panel on the rear of the switch, as follows:
One connection is for the multi I/O cable.
This connection corresponds to the left slot (when viewing the front of the
Meridian 1 switch).
The other connection is for the external SCSI device.
This connection corresponds to the right slot (when viewing the front of the
Meridian 1 switch).
For information about slot and rear bulkhead wiring, refer to the Meridian 1 System
Installation and Maintenance Guide (NTP 553-3001-210).
Local area network
If you have a LAN (for example, CLAN or ELAN), the LAN must be configured and
the appropriate networking equipment must be available.
If the LAN is to be networked with the 201i server, you need a network specialist to
ensure proper configuration.
Part 2: 201i Server Hardware Installation
Installing the server and connecting the peripherals
39