Installing The Scsi Cables For Meridian 1 - Nortel CallPilot Installation And Configuration Manual

Installing the server and connecting the peripherals

Installing the SCSI cables for Meridian 1

Introduction
Before you can connect a CD-ROM or tape drive to the 201i server, you must install
the SCSI cables. The SCSI cables route the SCSI connection away from the 201i
server faceplate so that an external SCSI device can remain permanently connected.
Note: If you are installing the 201i server in an Option 11C, go to page 66. For
Option 11C Mini, go to page 73.
Cables you need
Two cables are required:
NTRH1408 (for connecting the 201i server to the Meridian 1 I/O panel)
Intermediate SCSI cable NTRH1408
NTRH1410 (for connecting an external SCSI device to the NTRH1408
connector on the Meridian 1 I/O panel)
The total length of the cable from the I/O panel is 4.1 m (13.3 ft).
60
Standard 1.0
201i server
faceplate
connector
I/O panel
connector
G101548
CallPilot