Setting Scsi Device Termination - Nortel CallPilot Installation And Configuration Manual

Installing the server and connecting the peripherals

Setting SCSI device termination

Introduction
If you will be connecting SCSI devices in a daisy chain, the last device in the daisy
chain must be terminated. This section describes how to terminate the SCSI devices.
ATTENTION
Supported daisy chain connection scenarios
The first device in a SCSI device daisy chain can be either the tape drive or the
CD-ROM drive. However, since the Tandberg SLR5 tape drive is already internally
terminated at the factory, Nortel Networks recommends that you connect the tape
drive as the last device.
Meridian 1
The following diagram shows the supported daisy chain and SCSI cable connections
for Meridian 1. The CD-ROM drive is the first device in the daisy chain. The tape
drive is the last device.
For more information about the cabling requirements, see "Installing the SCSI
cables for Meridian 1" on page 60.
SCSI device cabling for Meridian 1
To Meridian 1
NTRH1410
94
To recognize the new settings, ensure the CD-ROM and tape
drives are powered down before changing the device
termination.
Optional
NTRH9038
Tape drive
SCSI device cable
NTRH3502
NTRH9037
CD-ROM
drive
Standard 1.0
G101431
CallPilot