Nortel CallPilot Installation And Configuration Manual page 31

October 2000
Faceplate feature
Network and drive activity
LEDs (labeled as ECIS)
Reset button
Part 2: 201i Server Hardware Installation
Description
The E and C LEDs indicate the presence of network activity
for both the ELAN and CLAN interfaces (respectively). When
they are lit, they indicate that the interfaces are properly
attached to their respective hubs. When the LEDs are blinking,
there is network activity.
When the I and S LEDs are lit, it means that the IDE hard drive
and SCSI device are being accessed.
The reset button allows you to manually restart the 201i server
without removing it from the IPE shelf.
ATTENTION
Before you press the reset button, you must shut down
Windows NT. Press the reset button while Windows NT is
running only when you cannot shut down Windows NT
normally because of a system lockup.
About the 201i server
31