Setting The Cd-Rom Drive's Scsi Id And Dip Switches - Nortel CallPilot Installation And Configuration Manual

October 2000
Setting the CD-ROM drive's SCSI ID and DIP
switches
Introduction
This section describes how to set the CD-ROM drive's SCSI ID and DIP switches.
ATTENTION
Note: The CD-ROM drive discussed in this section is the Plextor UltraPlex external
SCSI CD-ROM drive (NTRH9037).
To set the CD-ROM drive SCSI ID
The SCSI ID setting is located on the back of the CD-ROM drive. (See the diagram
that follows.)
To change the SCSI ID, use the blade of a screwdriver to rotate the SCSI ID dial's
arrow to 3.
SCSI interface
connectors - in and out
Part 2: 201i Server Hardware Installation
To recognize the new settings, power down the CD-ROM drive
before changing the SCSI ID and DIP switches.
SCSI-Out
SCSI-In
Installing the server and connecting the peripherals
DIP SCSI ID
switches
1 2 3 4 5
PARITY EECT
SCSI ID
TERM BLOCK
TEST
R L
AC power input
Power
switch
G101176
91