Add Dns Server <Ip_Address; Add Filter <Filter_Name - 3Com 3C421600A Reference Manual

60 C 4: R
HAPTER OUTER
add dns server
<IP_address>
add filter
<filter_name>
C R
OMMAND EFERENCE
Parameter
datalink ppp
enabled
interface
user
preference <priority_rating>
name <server_name and domain_name>
Adds the IP address of a remote DNS server to the Domain Name Server
Table. The preference number specifies the order DNS servers in this table
are accessed, with 1 as the highest preference and 10 as the lowest. The
first specified server is sent the IP Host Name to be resolved, first with,
then without the default domain name (see set dns domain_name
for more information about the default domain name). If that server
cannot resolve the name, it is sent to the next specified server.
The RAS 1500 attempts to reach each configured host three times in
round-robin fashion before issuing an error message. For instance, in the
case of three off-line servers, A, B, and C, the RAS 1500 admits failure
only after trying to reach them, one after the other, three times.
Parameter
<IP_address>
preference
name
Adds a filter file name to the Filter Table. The Filter Table is a managed list
of filter names used by Simple Network Management Protocol (SNMP). A
filter file is a text file stored in the FLASH file system that you load from an
external source using Trivial File Transfer Protocol (TFTP) or Web file load.
Add filter also verifies the syntax of the filter file. If syntax verification
fails, you receive an error message. The filter is added to the table, but it
is not usable. You must correct the filter file in a text editor, use TFTP to
export the updated file to the system FLASH file system, and use the
Description
Protocol that allows for the transfer of leased PPP packets over
a wide-area network synchronous serial line (leased line).
Optional parameter that indicates whether data link PPP is
enabled (YES) or disabled (NO).
Default is YES.
The port which data link PPP communicates over
(rm0/wan:1)
.
Username of the host on the on the private network
connecting to the RAS 1500. Limit: 32 ASCII characters.
Description
IP address of a server in nnn.nnn.nnn.nnn format.
Specifies the order in which name servers are used, with 1 as
the highest priority. Range: 1-10.
Designation (optional) of the name server. Limit: 64 ASCII
characters.