List Commands
list active interfaces
list appletalk
forwarding
list appletalk
networks
Displays information saved as entries in the RAS 1500 tables.
Displays the operational status, administration status, and name of all
active interfaces. The output is the same as that from the list interfaces
command, except nonactive interfaces are not displayed. Inactive
interfaces are interfaces with no current connections. Oper(ational) status
indicates current operating state of the interface, UP or DOWN.
Admin(istrative) Status indicates the permanently configured status of the
interface, UP or DOWN. For modem interfaces, Oper Status is down only
if you disable the modem.
Interface Name
loopback
internal
rm0/eth:1
rm0/slot:1/mod:1
rm0/slot:1/mod:2
pem0/slot:2/mod:1
pem0/slot:2/mod:1
Displays the entries in the AppleTalk forwarding table. The table lists the
following:
Network Address Range — AppleTalk network address range.
NextHop — Address of next hop router; 0.0 implies entry is a local
network.
Protocol — Always Routing Table Maintenance Protocol (RTMP).
Modified Time — Time the entry was last modified.
UseCount — Number of times this entry has been used.
Port — Port number.
Displays the configured AppleTalk networks. The table lists the following:
Name — AppleTalk network name.
Prot — Protocol, always Appletalk.
Int — Interface this network uses.
State — Possible states:
Oper Status
Admin Status
Up
Up
Up
Up
Up
Up
Up
Up
Up
Up
Up
Up
Up
Up
List Commands
97