SNMP Configuration
Tables
SYSLOG Table
Event Critical
Messages Table
Filter and Associated
Tables
File Table
Network Services and
Available Servers
Tables
The RAS 1500 provides support for SNMP version 1 and industry standard
MIB-II variables. These variables are fully described in your MIB-II
documentation.
The SNMP Community Table stores information about which SNMP
servers (if any) are permitted to make SET and GET requests, as well as
Read and Write Communities.
The SNMP Trap Community Table saves names and addresses of trap
communities.
The SNMP Community table saves names and addresses of communities
as associated pools.
This table contains IP addresses of SYSLOG hosts to which event
messages are sent. You can define multiple SYSLOG hosts that record
event messages by the message's log level. Use the
command to display this table.
This table contains event messages logged critical. Using the
list critical events
dial-in sessions as well as the default Console session.
Filter file names of filters you create are stored in the Filter Table but the
filters themselves are stored as ASCII text in FLASH memory. The Access
Filter Table determines whether user filters take precedence over interface
filters. Use the
list filters
This table contains system files and other files you may have loaded in the
RAS 1500 including filter files. Use the
this table.
The Network Services and Available Servers tables hold information
related to the RAS 1500-supported network services such as Telnet,
SNMP, ClearTCP, Dial-Out, and Trivial File Transfer Protocol (TFTP). These
default services can be edited or new services created with the
set network services
and
list available servers
Configurable Table Overview
command displays these messages to Telnet and
command to display this table.
list files
commands. Use the
list network services
commands to display these tables.
27
list syslogs
command to display
and
add