Troubleshooting Commands; Viewing Facility Errors; Terminating An Active Process; Resolving Addresses - 3Com 3C421600A Reference Manual

Troubleshooting
Commands
Viewing Facility
Errors
Terminating an Active
Process

Resolving Addresses

The command allows you to set and view log levels for the
set facility
system processes, ensuring that error messages reaching the threshold for
that facility are output to the console port.
Although messages are sent to the Console port by default, you can
configure a SYSLOG host to receive and save messages. See Appendix D,
"Event Messages" for more information.
Log levels range from the lowest state, debug, to the highest, critical. The
default is critical. Use the following command:
set facility <name> loglevel [common|critical|debug|unusual|
verbose]
Example:
set facility snmp loglevel unusual
Use the
list facilities
The command terminates an ongoing process. You can kill a process
kill
only after it has started. For instance, if you want to kill a
that has run too long. Use the
current active processes.
The command performs IP address resolution. Use the following
arp
command:
arp <ip address or host name>
The system responds with an IP address (and MAC [Ethernet] address if
found on a locally connected network) of the host.
Example:
ARP: 172.122.120.118 -> 08:00:09:cc:58:bf

Troubleshooting Commands

command to view a log level change.
list processes
39
request
ping
command to view